Guided by Japanese writings from an era of shoguns, an international team of scientists today reported new evidence that an earthquake of magnitude 9 struck the northwestern United States and southwestern Canada three centuries ago. The findings are likely to affect the region’s precautions against future earthquakes and tsunamis.
Writing this week in the American Geophysical Union’s Journal of Geophysical Research, scientists from Japan, Canada and the United States summarize old reports of flooding and damage by a tsunami in 1700 on the Pacific coast of Japan. With the aid of computer simulations, they conclude this tsunami required a North American earthquake close to magnitude 9. Such an earthquake, in a few minutes, would release about as much energy as the United States now consumes in a month. The report’s authors are Kenji Satake, of the Geological Survey of Japan; Kelin Wang, of the Geological Survey of Canada; and Brian Atwater, of the United States Geological Survey based at the University of Washington in Seattle.
The earthquake apparently ruptured the full length of an enormous fault, the Cascadia subduction zone, which extends more than 600 miles along the Pacific coast from southern British Columbia to northern California. Until the early 1980s, this fault was thought benign by most scientists, said USGS’s Atwater. But then a swift series of discoveries in North America showed that the fault produces earthquakes of magnitude 8 or larger at irregular intervals averaging about 500 years. The most recent of the earthquakes, dated approximately by radiocarbon methods, occurred between 1680 and 1720.
These discoveries raised a further question: Can the fault produce earthquakes of magnitude 9? Such a giant earthquake would produce minutes of low-frequency shaking that might threaten tall buildings from Vancouver, British Columbia, to northern California. A giant Cascadia earthquake would also warp large areas of seafloor, thereby setting off a train of ocean waves — a tsunami — that could prove destructive even on the far side of the Pacific Ocean.
That guess was on target according to today’s report, which was published online by the American Geophysical Union. The researchers begin by showing that the 1700 tsunami crested as much as 15 feet high in Japan. They then use recent findings about the Cascadia subduction zone to relate earthquake size to plausible areas of fault rupture and seafloor displacement. Finally, they employ computer simulations of trans-Pacific tsunamis to tune the estimates of earthquake size at Cascadia to the estimated tsunami heights in Japan.
Under construction standards adopted since 1996, engineers have sought to design buildings to withstand giant earthquakes in the northwestern United States. At the same time, state and local officials have devised evacuation routes from areas believed subject to a tsunami from a Cascadia earthquake of magnitude 9. In Canada, buildings in Vancouver and Victoria since 1985 have been built to resist stronger shaking from local earthquakes than is expected from the next Cascadia earthquake; Canada’s 2005 building code will explicitly include the hazard from the subduction zone, said Wang.
Japanese scientist Satake noted that since their first report in 1996 about the possible relation between the Japanese documents and the American earthquake, the Geological Surveys of the three countries began a joint project on the Cascadia earthquake. “As a result of this international collaboration, we have collected more evidence, made rigorous interpretation of it, and have modeled the earthquake source and tsunami propagation by using the latest techniques. Consequently, we have confirmed that the 1700 earthquake was magnitude 9.”